Andy
You said: If the pre-softener system does as it is designed, then iron for the softener hardware should not be an issue. Something is overloaded, undersized or not properly set up.
* What is the pre-softener system. Are you referring to the chlorine injector?
The chlorine is in excessive of 3ppm after the holding tank and before the carbon filter and softener. I am reducing this on a trial and error basis until I get your recommended .3 to .7 ppm.
* Can you confirm the water is routed correctly. It goes from the pressure tank thru the chlorine injector into the holding tank on to the carbon filter and lastly in to the softener. Is this correct?
* Does a softener rate of 8 lbs per recharge sound about right for 2 people.
Tim
Thanks,
Tim
|