[bashir2008]

Hello everybody..

I have aquestion and hope to get help..please bear with me and try to finish reading my question..

Thank u very much for your time.

My question is

I have a pilot plant filter.. and i need to add some chemicals to the raw water before entering the filter..say for instance the water flow rate is around 20L/h

the concentration of the chmical solution is %10.. and i need to add (dose) 5mg/L...which means 5mg of the chemials to 1L of water (flows in pipe before the filter )..
My question is how much (liter or milliters ) of the solution (chemicals) should i dose it to the water to give me the 5mg/l ?
I need to solve this problem in order to get the specification of the right dosing pump that i need to buy..
So please try to help me out with this.
Thank u very much

[showerob]

hello bashir2008,

Could you explain clearly what you are looking for? I was trying to figure out what you want but a bit confused. Thinking about the mass balance, is your exit product 10% solution, or simply 5 mg/l?