Results 1 to 2 of 2

Thread: O-ring problem

  1. #1
    Hydrocompus_Jim Guest

    Default O-ring problem

    Hello, this is a new member here

    We sold a RO system with output ranging are 600 GPD to a customer, after receipt this equipment, our client complained the 4 inches 300 PSI FRP membrane housing have a problem, its O-ring is slip on, with no gravel. It slipped out every time the end cap is taken out.

    But it is our design, according to our technical experiences, no O-ring groove, it can make us to take down the end plate and RO membrane easily, then, the O- ring can slip out automatically. When the RO membrane was installed in, and the raw water has entered into the vessel, the O-ring can not be slipped on, because it will be supported by the water pressure.

    Could you tell me your attitude? Thank you!

    Jim

  2. #2
    Andy CWS is offline Moderator
    Join Date
    Dec 2006
    Location
    Port Clinton, Ohio, United States
    Posts
    750

    Default

    What is the make. model and any other data on the equipment?

    Andy Christensen, CWS

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •