Search:

Thank you! I'll give it a try. Hopefully this is going to take care of things. Getting water dialed in is a lot of work! Thanks again for your help.

Thanks for the clarification on things. That is very helpful. So my only remaining question is how to deal with this long term. Is bacteria and odor going to be a problem even after the rod is gone?

So you agree it is the anode rod? I should just be carefull when pulling to out is what you are saying?

Raise to 140? Can I just keep it at that temp? If not how do I battle the continued problem?

I just have to figure out how to raise the temp. It is an electric WH. To pull the rod, I should shut the cold supply off and drain the WH a bit. Correct? Do I need to cut the power to the unit? Once...

Thanks. Is this hard to do? I have learned it is accessible under a plastic cap between the in and out. I have been told I will need a break over bar and second person to stabilize the heater. What...

We are getting things dialed in at our new home. A kinetico softner with a pre filter and a kinetico RO system has our water looking and tasting great! However, on the hot water side of things I...

Success! The new o-ring seal everything up beautifully. The brine float was all ready chipped back to "J" so I guess I will be using 4.4lbs of salt instead of the recommended 4. So we will see how it...

Thanks Andy. No not yet. I don't seem to get notified of new PM's. Weird.

I mostly spoke to Rick Harris (a wealth of knowledge, expertise, and kindness). I was also helped by a very nice lady....

Thanks all. I just received some additional schooling from the ever helpful folks at the Rabb Kinetico shop in Grabill, Indiana. I bought a new o-ring, and new filter, and a new filter set for the RO...

Thanks Andy,

Yes the system was from Rabb's Kokomo location. I am going to the Grabil Rabb location today over lunch to pick up a new o-ring.

I'll see how the new o-ring works with silicone...

See replies below your comments and questions. Thanks!

I am looking for Andy! I was referred here from another forum. Here are my questions. Thanks so much, in advance.

Hello! I just acquired a slightly used Mach system and RO unit for our new home on...