Autotrol 460i - flow is not blinking
I acquired a used 460i system. Followed the directions and installed it.
When I manually recharge, it seems to work properly. Water goes down, then comes back up in the brine tank, etc.
But, I have a couple of questions:
1) The flow light does not blink when water is flowing. I see the drawing in the manual to take the turbine out and clean it, but that drawing doesn't make sense to me. Does someone have a better picture that I can look at?
2) Since the system had been sitting in a shed, should I be concerned about "stuff" living in the tank, or is a good backwash be sufficient?
Thanks for the help.