Replacement for Model Pentek RO-3500 Reverse Osmosis System
Pentek SH244881 RO Filtration System Faucet
The Pentek SH244881 is the correct replacement for the following systems:
- Pentek RO-3000 Reverse Osmosis System
- Pentek RO-3500 Reverse Osmosis System
- Ametek Reverse Osmosis System
- American Plumber Reverse Osmosis System
- Culligan Reverse Osmosis System
- US Filter Reverse Osmosis System
The Pentek RO Filter System Faucet is a long-reach, lead-free replacement mounting faucet. Also known as part number SH244881, this filter faucet fits Pentek, American Plumber, Ametek, Culligan and US Filter Reverse Osmosis Systems. An air gap is required by most plumbing codes to prevent waste water back flow. Replace your drinking water faucet when needed. Do not use water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.
Pentek SH244881 Reverse Osmosis Faucet specifications:
- Part SH244881
- Air gap is required
- Replace faucet when needed
- Fits Pentek RO-3000, Pentek RO-3500 and other selected reverse osmosis systems.
After loosening the brass stem-nut on your reverse osmosis faucet, remove the metal "C" disc. While holding your Pentek faucet, feed the three tubes through the hole in the sink. Position the faucet handle at your desired location. Center the faucet and slip the "C" disc between the white spacer and the bottom of the counter or sink. Tighten the stem nut with a wrench until it is tight. Make sure that the handle of your faucet is in the down position and use a pair of needle-nose pliers to pull the short plastic tube out of the top of the faucet base. Lubricate the o-rings on the bottom of the faucet spout with your supplied silicone lubricant. Insert the goose-neck spout into faucet base firmly.
Pentek SH244881 RO Filtration System Faucet Product Reviews :Write a review
- Not reviewed yet