3M Aqua-Pure AP810, 56189-02 Sediment Water Filter Cartridge

Customers Who Bought This Item Also Bought

Your home's drinking water is going to get a whole lot better with the 3M Aqua-Pure AP810, 56189-02 Sediment Water Filter Cartridge! It's recommended to replace the AP810 every 6 months for the best performance and efficiency. The Aqua-Pure AP810 10" sediment filter reduces sediment down to 25 microns, which produces great tasting water without chlorine taste and odor or sediments.

Specifications:

• Brand: Aqua-Pure
• Part Number: AP810
• Pack Size:
• Filter Media: Polypropylene
• Micron Rating: 5
• Flow Rate: 20 gpm
• Operating Pressure: 0-100 psi
• Operating Temperature: 40-100° F

Additional Features:

• Grooved cartridge increases surface area for longer cartridge life
• Rigid construction helps to eliminate sediment unloading due to variances in water pressure
• Reduces dirt, sand, sediment and rust particles
• Ideal for larger (2.5 baths) homes and commercial application
• 1-year limited warranty gives you peace of mind

How do you install the 3M Aqua-Pure AP810?

• Prepare a bucket with clean soapy water ahead of time because once you open the filter housing you probably won't have access to water until you're finished.
• Turn your water supply off. You probably have a shutoff on the supply line located before the filter. If not, go to the hydro panel and turn the pump off.
• Relieve the water pressure on the lines before you unscrew the housing that holds the AP810 water filter. You can turn a faucet on inside the house to relieve pressure and let the water run until it stops. Then, shut off the water after the filter housing to keep the water from the house from draining back.
• Place a bucket under the filter housing. If the housing has a relief button push that to make sure all the pressure is gone. Unscrew the housing and take it off.
• Remove the old AP810 filter and clean the inside of the housing with soapy water and towels to remove any built-up debris. Unwrap and put the new AP810 filter in the housing and screw the housing back in place, slightly more than hand tight.
• Turn the faucet off that you had running to relieve pressure. Turn the main water supply back on, slowly. Check for leaks around the cartridge housing.
• Flush the new AP810 filter with at least 3 or 4 gallons of water or until the water flowing after the filter is clear.

How often should you replace the 3M Aqua-Pure AP810?

• Changing your 3M Aqua-Pure AP810 is a very quick and easy process that should be done once every six months.

What contaminants does the 3M Aqua-Pure AP810 reduce?

The 3M Aqua-Pure AP810 reduces the following contaminants:

• Dirt
• Rust
• Sediment

Resources:

• 3M Aqua-Pure AP810 Data Sheet