Hydronix SDC-25-2005 Replacement for Filters Fast® FF20S-5 Sediment Water Filter Cartridge

Customers Who Bought This Item Also Bought

The Hydronix SDC-25-2005 Replacement for Hydronix SDC-25-2005 Sediment Water Filter Cartridge doesn't skimp on performance, despite being an inexpensive alternative. This compatible filter cartridge removes extra fine sand, silt, dirt, rust, and scale from your tap water. The SDC-25-2005 water filter is also made of spun-bonded polypropylene that is designed to enhance purity, chemical compatibility and will resist chemical and bacterial attack. Featuring an impressive 5-micron rating, this water filter is excellent for residential and commercial applications where sediment removal is necessary.

Specifications:

• Brand: Hydronix
• Part Number: SDC-25-2005
• Replaces Part Number: SDC-25-2005
• Pack Size: 1
• Dimensions: 2-1/2" x 19-7/8"
• Filter Media: Spun Bonded Polypropylene
• Flow Rate: 20 gpm
• Filter Life: 3 months (depending on water quality and usage)
• Filter Rating: 5 microns

How do you install the Hydronix SDC-25-2005?

1. Turn your water supply off. You probably have a shutoff on the supply line located before the filter. If not, go to the hydro panel and turn the pump off.
2. Release any water pressure in the water lines before you unscrew the water filter housing. You need to turn a faucet on inside the house to release the pressure and let the water run until it stops or at least slows to a trickle. Then shut off the water after the filter housing to keep the water from the house from draining back through the open filter housing.
3. Place a bucket under the filter housing. Unscrew the housing and take it off being careful to minimize spilling the water from inside the housing.
4. Remove the old Hydronix SDC-25-2005 filter and clean the inside of the housing with soapy water and towels to remove any built-up debris. Check to make sure that there are no old rubber gaskets inside the filter housing.
5. Put some clear plumbers silicone grease on the O-ring, which will help preserve the O-ring, make it seal better and make it easier to remove the next time. Unwrap and slide the new Hydronix SDC-25-2005 filter into the housing and screw it back in place, slightly more than hand tight.
6. Turn the faucet off that you had running to release pressure. Turn the main water supply back on, partially. Check for leaks around the cartridge housing if there are no leaks, open main water supply fully.
7. Flush the new Hydronix SDC-25-2005 filter with at least 3 or 4 gallons of water or until the water flowing after the filter is clear.

How often should you replace the Hydronix SDC-25-2005?

• Changing your Hydronix SDC-25-2005 is a very quick and easy process that should be done once every 3 months.

What contaminants does the Hydronix SDC-25-2005 reduce?

• The Hydronix SDC-25-2005 reduces the following contaminants:

  • Chlorine taste and odor