Hydronix SPC-45-1030 Replacement for GE FXHSC Whole House Water Filter Cartridge

Customers Who Bought This Item Also Bought

The Hydronix SPC-45-1030 Replacement for GE FXHSC Whole House Sediment Water Filter Cartridge can sustain high flow rates and it offers greater dirt holding capacity than smaller diameter cartridges. The Hydronix SPC-45-1030 is also designed with durable synthetic fiber material that traps particles down to 30 microns to improve water quality that flows through fixtures and into appliances.

Specifications:

• Brand: Hydronix
• Part Number: SPC-45-1030
• Replaces Part Number: FXHSC
• Micron Rating: 30
• Flow Rate: 10 GPM
• Filter Media: Pleated Polyester
• Filter Life: 6 months (depending on water quality)
• Dimensions: 9 3/4" x 4 1/2"
• Temperature range: 40 to 125 ° F

How do you install the Hydronix Replacement for GE FXHSC?

1. Turn off water supply. Press red pressure-relief button (if present).
2. Unscrew housing. Remove large o-ring, wipe clean and set aside.
3. Discard used filter cartridge. Wash housing with dish soap and warm water using a nonabrasive sponge or cloth. Rinse thoroughly.
4. Fill 1/3 with water. Add about 1 tablespoon of bleach and scrub to disinfect. Rinse thoroughly.
5. Lubricate o-ring with clean silicone grease. Change o-ring if any damage cuts or degradation are present. Insert o-ring in groove.
6. NOTE: This step is important to ensure a proper housing seal. Make certain the o-ring is seated level in the groove.
7. Insert new filter cartridge.
8. Screw housing onto the cap and hand-tighten. Do not over tighten. Make sure cap standpipe slips into cartridge.
9. Turn on water supply. Press pressure-relief button (if present). Check for leaks before leaving installation.Most fit issues result from either an old cartridge o-ring that fell off when removing the old cartridge, or failing to get the standpipe lined up when hand tightening the housing.

How often should you replace the Hydronix Replacement for GE FXHSC?

• Changing your Hydronix Replacement for GE FXHSC is a very quick and easy process that should be done once every six months.

What contaminants does the Hydronix Replacement for GE FXHSC reduce?

• The Hydronix Replacement for GE FXHSC reduces the following contaminants:

  • Dirt
  • Sand
  • Rust
  • Scale Particles