The Pentek SH244820 is the correct replacement faucet for the following systems:
The Pentek Chrome Filter Faucet connects to the 2500 series Pentek Reverse Osmosis systems and fits through a 1 1/4" hole that should be mounted securely on an adequate flat surface. For controlled water flow, push the handle of this Pentek RO Faucet down and for constant water flow, be sure to lift the faucet hand to lock it in the open position. Also known as part number SH244820, this Pentek faucet comes in a contemporary chrome finish to complement your decor. Do not use water that is microbiologically unsafe or of unknown quality without adequate disinfection.
Pentek RO Drinking Water Faucet specifications:
When mounting your Pentek Filter Faucet, loosen your stem-nut and attach the large 3/8" drain tube to the barb fitting at the base of the faucet. Attach the small 1/4" drain tube to the other barb fitting at the base of the faucet. Slide the chrome place and black rubber washer on the faucet by threading both drain tubes through the holes located on the plate and washer. Next slide the lock washer down the threaded section and thread stem nut. Do not tighten the stem nut yet. Insert the tubing and slide the nut over the tubing. Push the tubing into the bottom of the faucet stub, slide the ferrule up and then slide the nut up and screw it to the faucet. Tighten until you feel a slight resistance.