Sani-System Water Softener Sanitizer 50032
The Sani-System 50032 is the correct liquid sanitizer to use in the following applications:
- Water Coolers
- Reverse Osmosis (RO) Systems
- Water Softener Filtration Systems
The Sani-System Water Softener Sanitizer helps to reduce 99.9% of unsafe bacteria without using oxidizers, acids or chlorine that could harm the equipment parts and resin of your water filtration system. The Sani-System Sanitizer meets EPA approval and NSF certification. In 60 seconds each pre-measured packet is a concentrated formula used to sanitize your water filtration equipment.
Sani-System Water Softener Sanitizer Specifications:
- Part 50032
- EPA and NSF Approved
- Cases contain 0.5 oz. packets
- Reduces 99.9% of harmful waterborne contaminants
- Fits Reverse Osmosis Systems, Water Coolers and Water Softener Filtration Systems
The Pro Sani-System Sanitizer is ideal for using in the following applications:
Reverse Osmosis (RO) Systems: First shut off the water supply to the RO system, then remove the membrane and all filters. Turn off the pump if applicable. Pour the entire contents of the Sani-System Sanitizer into the main housing unit and then fill with drinkable water.
Water Softeners: Begin by mixing a solution of 2 cups of water, along with one packet of sanitizer, then pour the contents into the brine well. If there is not a brine well present, proceed by pouring the solution in the bottom of the salt tank when the salt level is low. Regenerate the softener manually.
Water Coolers, Ice Machines and Pressure Tanks: Start by mixing the entire contents of the sanitizer packet with 4 gallons of water. Next, pour the solution into a hand sprayer. After spraying your desired location for sanitization, allow it to saturate for approximately 60 seconds. Finally, rinse and flush your system with drinkable water to help guarantee that the solution is thoroughly rinsed from your system.
Sani-System Water Softener Sanitizer 50032 Product Reviews :
Write a review