3M Aqua-Pure AP117 Replacement for Filters Fast® FF10C-5-AP - 2-Pack

The 3M Aqua-Pure AP117 Replacement for Filters Fast® FF10C-5-AP - 2-Pack is a set of chlorine water filters that reduce chlorine taste & odor, dirt, sand, sediment and rust particles from your water. This two pack of 3M Aqua-Pure water filters can be used in the below filtration systems and any other water filter system from major manufacturers requiring a standard size cartridge. The 3M Aqua-Pure AP117 water filter is also a direct replacement for the WHCF-GAC cartridge and WHKF-GAC.

Specifications:

• Brand: 3M Aqua-Pure
• Part Number: AP117, 5541714
• Replaces Part Number: FF10C-5-AP
• 3M ID Number: 7100057796
• Pack Size: 2
• Filter Life: 6 Months (10,000 Gallons)
• Micron Rating: 5
• Dimensions: 9.75" x 3"
• Flow Rate: 3 gpm
• Note: The AP117 does not fit the Waterpick K-50 or K50 system.

Additional Features:

• Use with cold water only
• Graded density for up to 30% longer life
• Specially Formulated High-Absorption Activated Carbon
• Triple Action for Dirt, Rust, Chlorine Taste and Odor Reduction

How do you install the 3M Aqua-Pure AP117 Replacement for Filters Fast® FF10C-5-AP?

1. Turn off the water supply. Press the red pressure-relief button (if present).
2. Unscrew housing. Remove large o-ring, wipe clean, and set aside.
3. Discard used filter cartridge. Wash housing with dish soap and warm water using a nonabrasive sponge or cloth. Rinse thoroughly. Fill 1/3 with water. Add about 1 tablespoon of bleach and scrub to disinfect. Rinse thoroughly.
4. Lubricate o-ring with clean silicone grease. Change o-ring if any damage cuts or degradation are present. Insert o-ring in the groove.
   NOTE: this step is important to ensure a proper housing seal. Make certain the o-ring is seated level in the groove.
5. Insert the new 3M Aqua-Pure AP117, 5541714 filter cartridge.
6. Screw housing onto the cap and hand-tighten. do not overtighten. Make sure cap standpipe slips into 3M Aqua-Pure AP117, 5541714 cartridge.
7. Turn on the water supply. Press the pressure-relief button (if present). check for leaks before leaving installation.

How often should you replace the 3M Aqua-Pure AP117 Replacement for Filters Fast® FF10C-5-AP?

• Changing your 3M Aqua-Pure AP117 Replacement for Filters Fast® FF10C-5-AP is a very quick and easy process that should be done once every six months.

What contaminants does the 3M Aqua-Pure AP117 Replacement for Filters Fast® FF10C-5-AP reduce?

• The 3M Aqua-Pure AP117 Replacement for Filters Fast® FF10C-5-AP reduces the following contaminants:

  • Chlorine Taste & Odor
  • Sediment

Ask Our Product Experts