Filters Fast® FF10BBS-25 Replacement for Aqua-Flo RF-10BV

The Filters Fast® FF10BBS-25 Replacement for Aqua-Flo RF-10BV Carbon Water Filter features a 25 micron rating. This filter has no problem stopping particulates that are invisible to the human eye. No need for complex filtration materials or expensive alternatives with this workhorse of a filter. Insert the filter into any standard size housing that accepts 4.5" x10" filters, connect the water lines, and you'll have water that is free of sediments and has fewer chlorine tastes and odors. This filter should be changed every six months for optimal performance.

Specifications:

• Brand: Filters Fast
• Part Number: FF10BBS-25
• Replaces Part Number: RF-10BV
• Pack Size: 1
• Filter Media: Radial-flow carbon
• Filter Life: 6 months or 5,500 gallons
• Dimensions: 10" x 4 1/2"
• Micron Rating: 25-micron (nominal)
• Initial Pressure Drop: 0.9 psi at 2 GPM

How do you install the Filters Fast® FF10BBS-25 Replacement for Aqua-Flo RF-10BV?

1. Turn off water supply. Press red pressure-relief button (if present).
2. Unscrew housing. Remove large o-ring, wipe clean and set aside.
3. Discard used filter cartridge. Wash housing with dish soap and warm water using a nonabrasive sponge or cloth. Rinse thoroughly.
4. Fill 1/3 with water. Add about 1 tablespoon of bleach and scrub to disinfect. Rinse thoroughly.
5. Lubricate o-ring with clean silicone grease. Change o-ring if any damage cuts or degradation are present. Insert o-ring in groove.
6. NOTE: This step is important to ensure a proper housing seal. Make certain the o-ring is seated level in the groove.
7. Insert new filter cartridge.
8. Screw housing onto the cap and hand-tighten. Do not over tighten. Make sure cap standpipe slips into cartridge.
9. Turn on water supply. Press pressure-relief button (if present). Check for leaks before leaving installation.Most fit issues result from either an old cartridge o-ring that fell off when removing the old cartridge, or failing to get the standpipe lined up when hand tightening the housing.

How often should you replace the Filters Fast® FF10BBS-25 Replacement for Aqua-Flo RF-10BV?

• Changing your Filters Fast® FF10BBS-25 Replacement for Aqua-Flo RF-10BV is a very quick and easy process that should be done once every six months.

What contaminants does the Filters Fast® FF10BBS-25 Replacement for Aqua-Flo RF-10BV reduce?

• The Filters Fast® FF10BBS-25 Replacement for Aqua-Flo RF-10BV reduces the following contaminants:
  • Sediment
  • Bad Taste & Odor

Ask Our Product Experts