10"X4.5" 5 Micron Pleated Polyester Filters Fast® FF10BBP-5 Replacement Pleated Water Filter Cartridge

The Filters Fast® FF10BBP-5 Replacement Pleated Water Filter Cartridge reduces waterborne particles and contaminants like sediment, rust, silt and sand. This whole-house filter is built from durable non-woven polyester that is resistant to chemicals and bacteria. The pleated construction provides excellent dirt-holding capacity while maintaining a 20 GPM flow rate. The Filters Fast® FF10BBP-5 also provides higher wet strength than regular cellulose cartridges. The Filters Fast® FF10BBP-5 Replacement Pleated Water Filter Cartridge is best for use in a variety of residential, commercial and industrial applications. Replace your water filter today!

Specifications:

• Brand: Filters Fast®
• Part Number: FF10BBP-5
• Replaces Part Number: ECP5-BB
• Pack Size: 1
• Filter Life: 6 months or 5500 gallons
• Filter Media: Pleated Polyester
• Dimensions: 4-1/2" x 9-3/4"
• Micron Rating: 5
• Flow Rate: 20 GPM
• Reduces extra-fine sand, rust, dirt, silt and scale particles

How do you install the Filters Fast® FF10BBP-5?

1. Turn your water supply off. You probably have a shutoff on the supply line located before the filter. If not, go to the hydro panel and turn the pump off.
2. Release any water pressure in the water lines before you unscrew the water filter housing. You need to turn a faucet on inside the house to release the pressure and let the water run until it stops or at least slows to a trickle. Then shut off the water after the filter housing to keep the water from the house from draining back through the open filter housing.
3. Place a bucket under the filter housing. Unscrew the housing and take it off being careful to minimize spilling the water from inside the housing.
4. Remove the old filter and clean the inside of the housing with soapy water and towels to remove any built-up debris. Check to make sure that there are no old rubber gaskets inside the filter housing.
5. Put some clear plumbers silicone grease on the O-ring, which will help preserve the O-ring, makes it seal better and makes it easier to remove the next time. Unwrap and slide the new Filters Fast® FF10BBP-5 filter into the housing and screw it back in place, slightly more than hand tight.
6. Turn the faucet off that you had running to release pressure. Turn the main water supply back on, partially. Check for leaks around the cartridge housing if there are no leaks, open main water supply fully.
7. Flush the new filter with at least 3 or 4 gallons of water or until the water flowing after the filter is clear.

How often should you replace the Filters Fast® FF10BBP-5?

• Changing your Filters Fast® FF10BBP-5 is a very quick and easy process that should be done once every 6 months.

What contaminants does the Filters Fast® FF10BBP-5 reduce?

• The Filters Fast® FF10BBP-5 reduces the following contaminants:

  • Chlorine taste and odor

Customer Reviews:

Total Reviews: 6 | Average Rating: 4.2 / 5.0

Dave2026-03-30

excellent quality filters excellent service

Collected by Trustpilot.com

RICHARD2025-12-16

RECEIVED AS ORDERED/PROMISED

Collected by Trustpilot.com

Scott M2025-12-08

Does not work as described. Too large for the canister

Collected by Trustpilot.com

Dave2025-01-29

Good quality filter and good price.

Collected by Trustpilot.com

John Feehan2021-06-11

Great product!

Collected by Trustpilot.com

Ken R. Watson2021-01-01

Good filter

Collected by Trustpilot.com