P5 Filters Fast® FF10S-5 Replacement for Pentek P5, 155014-43 Spun-Bonded Polypropylene Sediment Water Filter Cartridge

1. Prepare a a bucket with clean soapy water ahead of time because once you open the filter housing, you probably won't have access to water until you're finished.
2. Turn your water supply off. You probably have a shutoff on the supply line located before the filter. If not, go to the hydro panel and turn the pump off.
3. Relieve the water pressure on the lines before you unscrew the housing that holds the Filters Fast® FF10S-5 Replacement for Pentek P5, 155014-43 water filter. You can turn a faucet on inside the house to relieve pressure and let the water run until it stops. Then, shut off the water after the filter housing to keep the water from the house from draining back.
4. Place a bucket under the filter housing. If the housing has a relief button push that to make sure all the pressure is gone. Unscrew the housing and take it off.
5. Remove the old Filters Fast® FF10S-5 Replacement for Pentek P5, 155014-43 filter and clean the inside of the housing with soapy water and towels to remove any built-up debris. Unwrap and put the new Filters Fast® FF10S-5 Replacement for Pentek P5, 155014-43 filter in the housing and screw the housing back in place, slightly more than hand tight.
6. Turn the faucet off that you had running to relieve pressure. Turn the main water supply back on, slowly. Check for leaks around the cartridge housing.
7. Flush the new Filters Fast® FF10S-5 Replacement for Pentek P5, 155014-43 filter with at least 3 or 4 gallons of water or until the water flowing after the filter is clear.

Changing your Filters Fast® FF10S-5 Replacement for Pentek P5, 155014-43 is a very quick and easy process that should be done once every six months.

The Filters Fast® FF10S-5 Replacement for Pentek P5, 155014-43 is NSF 42 certified, which means that it reduces the following contaminants:

• Chlorine Taste and Odor Reduction