Pentair DGD-2501-20, 155360-43 Sediment Water Filter Cartridge

The Pentair DGD-2501-20, 155360-43 Sediment Water Filter Cartridge is a 2-in-1 that works as both a pre-filter and post-filter, which eliminates the need for step-down filtration systems in your home, and resists chemicals and corrosion. The outer-layer acts as a sediment filter with 25 micron particulate reduction, and the inner-layer further improves your water's quality with an impressive 1 micron rating.

Specifications:

• Brand: Pentair
• Part Number: DGD-2501-20
• Alternate Part Number: 155360-43
• Pack Size: 1
• Dimensions: 4-1/2" x 20"
• Micron Rating: 25 pre-filter; 1 micron post-filter
• Capacity: 8,000 gallons
• Filter Life: 3-6 months
• Operating Temperature: 40 -145°F
• Flow Rate: 20 GPM @ < 1 psi
• NSF Certification(s): 42

How do you install the Pentair DGD-2501-20?

1. Prepare a a bucket with clean soapy water ahead of time because once you open the filter housing, you probably won't have access to water until you're finished.
2. Turn your water supply off. You probably have a shutoff on the supply line located before the filter. If not, go to the hydro panel and turn the pump off.
3. Relieve the water pressure on the lines before you unscrew the housing that holds the DGD-2501-20 water filter. You can turn a faucet on inside the house to relieve pressure and let the water run until it stops. Then, shut off the water after the filter housing to keep the water from the house from draining back.
4. Place a bucket under the filter housing. If the housing has a relief button push that to make sure all the pressure is gone. Unscrew the housing and take it off.
5. Remove the old DGD-2501-20 filter and clean the inside of the housing with soapy water and towels to remove any built-up debris. Unwrap and put the new DGD-2501-20 filter in the housing and screw the housing back in place, slightly more than hand tight.
6. Turn the faucet off that you had running to relieve pressure. Turn the main water supply back on, slowly. Check for leaks around the cartridge housing.
7. Flush the new DGD-2501-20 filter with at least 3 or 4 gallons of water or until the water flowing after the filter is clear.

How often should you replace the Pentair DGD-2501-20?

• Changing your Pentair DGD-2501-20 is a very quick and easy process that should be done once every three to six months.

What contaminants does the Pentair DGD-2501-20 reduce?

• The Pentair DGD-2501-20 is NSF 42 certified, which means that it reduces the following contaminants:

  • Chlorine Taste and Odor Reduction

Resources:

• Pentek DGD Series Product Manual

California Residents: Prop 65 Warning

Customer Reviews:

Total Reviews: 5 | Average Rating: 5 / 5.0

John Gale2024-04-13

Best water filter ever. I have been using this filter for years to get purer watet as I have a well .

Collected by Trustpilot.com

Janice2024-02-12

Works great for my water system

Collected by Trustpilot.com

Kevin Walsh2023-12-01

I have a high iron content and this filter filters my water perfectly.

Collected by Trustpilot.com

customer2023-03-11

Excellent customer service, rocket fast shipping and well packaged. Excellent product.

Collected by Trustpilot.com

Fire Man2021-12-12

Very pleased using these filters for 10+ years

Collected by Trustpilot.com

The Filters Fast® Replacement for Pentair DGD-2501-20, 155360-43 Sediment Water Filter Cartridge is a 100% polypropylene filter contains graded density that provides higher dirt holding capacity than standard spun polypropylene and string wound cartridges. This Filters Fast® sediment water filter reduces waterborne contaminants like sand, silt, sediment and rust; and is ideal for residential, commercial, food service and industrial applications. Constructed with a coreless design, the FFDG-20BB-1 filter is surfactant-free, adhesive-free and binder-free. Shop the Filters Fast® replacement for the Pentair DGD-2501-20, 155360-43 today!

Note: Do not use this filter with water that is of unknown quality or microbiologically unsafe without adequate disinfection before or after the system.

Specifications:

• Brand: Filters Fast®
• Part Number: FFDG-20BB-1
• Pack Size: 1
• Filter Life: 6 months
• Dimensions: 20" x 4-1/2"
• Filter Media: Gradient density polypropylene
• Micron Rating: 1
• Flow Rate: 1 psi @ 20 gpm
• Operating Temperature: 40 to 145 degrees Fahrenheit (62.8 degrees Celsius)
• NSF Certification(s): 42

How do you install the Filters Fast® Replacement for Pentair DGD-2501-20, 155360-43?

1. Prepare a a bucket with clean soapy water ahead of time because once you open the filter housing, you probably won't have access to water until you're finished.
2. Turn your water supply off. You probably have a shutoff on the supply line located before the filter. If not, go to the hydro panel and turn the pump off.
3. Relieve the water pressure on the lines before you unscrew the housing that holds the Filters Fast® Replacement for Pentair DGD-2501-20, 155360-43 water filter. You can turn a faucet on inside the house to relieve pressure and let the water run until it stops. Then, shut off the water after the filter housing to keep the water from the house from draining back.
4. Place a bucket under the filter housing. If the housing has a relief button push that to make sure all the pressure is gone. Unscrew the housing and take it off.
5. Remove the old Filters Fast® Replacement for Pentair DGD-2501-20, 155360-43 filter and clean the inside of the housing with soapy water and towels to remove any built-up debris. Unwrap and put the new Filters Fast® Replacement for Pentair DGD-2501-20, 155360-43 filter in the housing and screw the housing back in place, slightly more than hand tight.
6. Turn the faucet off that you had running to relieve pressure. Turn the main water supply back on, slowly. Check for leaks around the cartridge housing.
7. Flush the new Filters Fast® Replacement for Pentair DGD-2501-20, 155360-43 filter with at least 3 or 4 gallons of water or until the water flowing after the filter is clear.

How often should you replace the Filters Fast® Replacement for Pentair DGD-2501-20, 155360-43?

• Changing your Filters Fast® Replacement for Pentair DGD-2501-20, 155360-43 is a very quick and easy process that should be done once every six months.

What contaminants does the Filters Fast® Replacement for Pentair DGD-2501-20, 155360-43 reduce?

• The Filters Fast® Replacement for Pentair DGD-2501-20, 155360-43 is NSF 42 certified, which means that it reduces the following contaminants:

  • Chlorine Taste and Odor Reduction

Customer Reviews

Total Reviews: 7 | Average Rating: 5 / 5.0

SUSAN NIELSON2023-09-29

It does the job in filtering our Well water.

Collected by Trustpilot.com

Marcy D2023-06-23

Works as well as the name brand for much less.

Collected by Trustpilot.com

John Modrich2022-06-19

Very happy with purchase.

Collected by Trustpilot.com

Vern J2021-12-26

Filter is as promised. I was pleased with the quality.

Collected by Trustpilot.com

customer2021-12-07

Great product and service.

Collected by Trustpilot.com

SUSAN NIELSON2021-05-24

We have an Arsenic problem in the water--levels are tolerable but extra filtering is necessary. Filter is changed every six months AND it is amazing how white it is at change AND how dirty/yuck color it is six months later. We filter our house water also--Never have drank from the tap. These filters impressed me and will continue to purchase

Collected by Trustpilot.com

Jerry Edmisten2021-01-04

I've been buying from this company for years. Great service and prices will never change. Thank you

Collected by Trustpilot.com